英语翻译1.轴承用润滑油牌号为HU_32,转动油盆内注油量约为54升,储油箱内注油量约为86升,润滑油油质须清洁.2.轴
来源:学生作业帮 编辑:大师作文网作业帮 分类:英语作业 时间:2024/09/30 00:27:12
英语翻译
1.轴承用润滑油牌号为HU_32,转动油盆内注油量约为54升,储油箱内注油量约为86升,润滑油油质须清洁.
2.轴承冷却水水质应清洁,用水量约为15T/h,冷却水工作压力为0.0.2MPa.
3.工地安装时,除转动油盆及转动油盆盖外,其余各部件分半面均须涂7303密封胶.
4.轴承共设2只温度计,其中1只装在溢油板上用于测油温,另1只装在轴承体上,1只用于瓦温监测,另1只用于报警.
5.轴承正常运行时允许最高温度不超过65℃,当温度升至60℃时,机组自动化元件发出报警信号,超过70℃时须停机.
6.工地安装轴承管件时须密封严实,不允许渗漏.
用翻译软件翻译出来的不是很准确,如果有英语高手人工翻译就更好了。
1.轴承用润滑油牌号为HU_32,转动油盆内注油量约为54升,储油箱内注油量约为86升,润滑油油质须清洁.
2.轴承冷却水水质应清洁,用水量约为15T/h,冷却水工作压力为0.0.2MPa.
3.工地安装时,除转动油盆及转动油盆盖外,其余各部件分半面均须涂7303密封胶.
4.轴承共设2只温度计,其中1只装在溢油板上用于测油温,另1只装在轴承体上,1只用于瓦温监测,另1只用于报警.
5.轴承正常运行时允许最高温度不超过65℃,当温度升至60℃时,机组自动化元件发出报警信号,超过70℃时须停机.
6.工地安装轴承管件时须密封严实,不允许渗漏.
用翻译软件翻译出来的不是很准确,如果有英语高手人工翻译就更好了。
Bearing grade lubricants for the HU_32,turning the oil basin is about 54 liters fuel injection,fuel injection storage box is about 86 liters,lubricating oil quality to be clean.
2.Bearing cooling water should be clean,water consumption is about 15T / h,cooling water working pressure of 0.1 0.2MPa.
3.Site installation,in addition to rotation and the rotating oil basin oil basin cover,the other half the parts to be coated surface sealant 7303.
4.Bearing consists of two thermometers,one mounted on a board used to measure oil temperature,oil spill,and the other one installed in the bearing body,the one used in tile temperature monitoring,and the other one for the alarm.
5.Bearing during normal operation to allow the maximum temperature does not exceed 65 ℃,when the temperature rose to 60 ℃,the unit alarm signal automation components,more than 70 ℃ to be shut down.
6.Site installation of bearing tube to be sealed JANSEN,does not allow leakage.
2.Bearing cooling water should be clean,water consumption is about 15T / h,cooling water working pressure of 0.1 0.2MPa.
3.Site installation,in addition to rotation and the rotating oil basin oil basin cover,the other half the parts to be coated surface sealant 7303.
4.Bearing consists of two thermometers,one mounted on a board used to measure oil temperature,oil spill,and the other one installed in the bearing body,the one used in tile temperature monitoring,and the other one for the alarm.
5.Bearing during normal operation to allow the maximum temperature does not exceed 65 ℃,when the temperature rose to 60 ℃,the unit alarm signal automation components,more than 70 ℃ to be shut down.
6.Site installation of bearing tube to be sealed JANSEN,does not allow leakage.
润滑油是否为危险化学品
英语翻译给曲轴轴承加注润滑油.
有关资料显示,每人每日正常饮水量约为1升.小红的水杯内直径4厘米,深10厘米,她每天需要喝几杯水?
在转动部分添加润滑油 为什么属于 通过变滑动为滚动而减小摩擦力
润滑油中一般含水量为多少
悠悠球什么轴承用润滑油A,什么用润滑油B,什么用润滑油A
机械加工需要用润滑油减小摩擦,某企业加工一台大型机械设备润滑油用量为90公斤,润滑油的重复利用率是60%
2.已知氚核的质量约为质子的3倍,带正电荷,电荷量为一个元电荷;α粒子即氦原子核,质量约为质子的4倍,带正电荷,电荷量为
小明和父母一起开车到距家200km的景区旅游,出发前油箱内储油45升,当行驶150km时,发现油箱剩余油量为30升,已知
小明和父母一起开车到距家200千米的景点旅游.出发前,汽车油箱内储油45升;当行驶150千米时,发现油箱剩余油量为30升
小强和父母一起开车到距家150千米的景点旅游.出发前,汽车油箱内储油20升,当行驶120千米时,发现油箱剩余油量为10.
“油堵”英语翻译盖住减速箱注油孔的油堵用英语怎么翻译?向各位求教