英语翻译1.start with positionging the loom in front of you so th

英语翻译
1.start with positionging the loom in front of you so that the serrated edges of the comb and the slotted ends are facing up.
2.using a tape measure,measure your wrist in the place that you want your new bracelet to be worn.
3.add 8 inches to the measure ment of your wrist and cut 4 lengths of loraiding floss to this length.
4.lay the floss flat making sure that the ends meet and tie a knot in the bundle of the threads 3 inches from the end.
5.with tape,stick the ends of the floss that you have just tied to the brace on the top beam.
6.pull the bundle of floss tight of that the floss lay flat and tie another knot 2 inches from the other end.
7.put the knot bundle(not the tape end)around the braces at the top beam.
8.wind the beam with the end of the floss that has stack with tape of that spare floss wap around the beam.continue winding unfil the knot reaches and is over the slotted plastic part.
9.before completely tightening the floss with the beam,separate the threads and put a single thread in a slot.this has to be repeated at the other end of the loom.
10.Make sure that the floos are ready to begin weaving,tighten the other beam.you loom is now ready and the fun begings.

1.start与positionging织机在您的面前,这样的锯齿状边缘,梳子和开槽目的是朝上.
2.using 1卷尺,测量你的手腕的地方,您希望您的新手链须佩带.
3.add 8英寸的测量你的手腕和削减4长度loraiding牙线这个长度.
4.lay绒毛单位做到收支平衡和打结的捆绑线程3英寸的结束.
5.with带,棒的两端牙线你刚才绑在支架上的顶梁.
6.pull的束牙线紧的绒毛奠定单位和领带又结2英寸的另一端.
7.put结束（而不是磁带完）围绕括号上方束.
8.wind的梁结束牙线有栈与磁带的备件的WAP牙线缠绕在联黎部队beam.continue结婚达到和超过了开槽塑料零件.
9.before完全收紧牙线与束,单独的线程,并把一个线程在slot.this要反复在另一端的织机.
10.Make确保floos准备开始编织,加强其他beam.you织机现在准备和乐趣begings .