作业帮 > 英语 > 作业

Saving new heights into memory:

来源:学生作业帮 编辑:大师作文网作业帮 分类:英语作业 时间:2024/10/06 04:04:18
Saving new heights into memory:
Once you have manually adjusted each air spring to the height that you wish to save,hold the position button#1,#2,or #3(the position #that you want the current height saved as)for 3 seconds until the po-sition indicator flashes,then becomes soild.
Note:this process can be repeated as often as desired
Re-saving position #3:
Press&hold the position #3 button for 3 seconds.
The position #3 indicator light will flash,then become solid when saving is complete.
Re-saving position #2:(ride height)
Press&hold the position #2 button for 3seconds.
The position#2 indicator light will flash,then become solid when saving is complete.
Re-saving position#1:
Press&hold the position#1 button for 3seconds.
The position#1 indicator light will flash ,then become solid when saving is complete
Saving new heights into memory:
保存新高度设定:
手动调整空气弹簧高度后,若要将该位置保存,请按住1、2或3号按钮(三个按钮分别对应想要存储的当前高度)保持3秒钟,相应按钮位置的指示灯将会闪烁,稍后停止闪烁.
注:该功能可随意反复使用
3号重新保存位置:
按住3号位置按钮保持3秒钟.
3号位置的指示灯将会闪烁,稍后存储完毕时指示灯停止闪烁.
2号重新保存位置:
按住2号位置按钮保持3秒钟.
2号位置的指示灯将会闪烁,稍后存储完毕时指示灯停止闪烁.
1号重新保存位置:
按住1号位置按钮保持3秒钟.
1号位置的指示灯将会闪烁,稍后存储完毕时指示灯停止闪烁.
自己翻译的,感觉是空气弹簧的使用说明书的一部分……不知道翻译的是否到位,您参考一下吧0.0